Electric Instant Hot Water Heater

Design Studio Entries RSS Comments RSS Login. The illustration above shows my installation.
With a address email find someone using life expectancy of up to 20 years (according to energystar. I found instructions on installing two heaters and bought another one.

So you may be pushing the limits of your panel’s capacity. My wife is about to eat me alive if i dont’ get this fixed.
Most panels have a maximum capacity of st francis hospital ny about 200 amps. Our two units work great for everything except for when trying to fill the bathtub. We do have to warn guests that use that bathroom to turn the shower on immediately which reduces the flow to around 2. Just shut the water valves supplying water to one of the heaters, as well as the breakers powering it. There was quite a few hours invested in cutting pipe, soldering, and wiring.

com » Tankless hot water heater installation Tankless hot water heater installation I wrapped up the installation of a tankless (”on-demand”) electric hot water system for the house over the weekend. I am certain that if we had used two 40 amp breakers that the heat output would have been greater. I just bought a SCR2 on Ebay & installed it.
I may try & make a separate single ground for the SCR2 using a pure copper rod & see what happens. I INSPECTED THE INSTALLAION AGAIN AND I DID NOT FIND NOTHING WRONG.

We do live in Alaska and it was winter.
I’ve followed the horrible directions given with the unit and still no hot water. The water temperature is very nice now and i have actually turned the temperature dials on both heaters to about the middle of the range of settings. Unfortunately the instructions that i followed online indicated that the heater needed only one double pole sixty amp breaker. And one unit should also have sufficient power to provide a good shower. Raul Herrero (no relation to Rey) Says: Thanks for the story zieak. My dual 60 amp breaker is in the second from the top position. i have checked the wires and body cat jewelry wild i cannot find what is wrong. Edit: Our additional electrical load actually caused the failure of a transformer out on the power pole outside of our house. Would it be the water heater capacity wasn’t fit for your local water flow rate? There are quite a few guides on the Internet in calculating the size (capacity) of the tankless water heater vs location simply googling it should get you to the right spot. . Now, about your flickering lights.
Then they increased the size of the line feeding the house from that transformer and now the lights just dim a little when you first turn the water on. The demand may just be too high. September 12th, 2007 at 5:23 pm I would try to get in touch with Martin at Titan. He also said the flickering could be caused from the breaker being at the bottom of the breaker box. Oki’ll bite on this spamI live in Alaska so the groundwater temperature is fairly low.

This is easy for us to deal with because we never remote off site backup use the bath.
This is the reason why your lights may be nifty exotic story archive flickering.
I INSTALLED THE GREEN WIRE TO THE GROUND CONTAC OF THE CIRCUIT BREAKER BOX AND THE 2 WHITE WIRES TO A DOUBLE 40 AM CB. 2 Titan SCR4 heaters @ $450 each =$900 4 40 amp double pole breakers @ $21 each (only $10 each at Lowe’s) = $84 9 feet of 8/2 wire and wire nuts = $20 6 1/2 inch gate valves with compression fittings @ $10 each = $60 Copper pipe and fittings ~ $80 A standard electric hot water heater with a tank would have cost about half that.
The only drawback we have is that all the lights in the house have a slight flicker to them when hot water is being used.

They replaced the transformer and the lights didn’t flicker as much when we used water. NOTE:INSIDE THE BOX OF MAREY MODEL I DID NOT FIND ANY GUIDE OR LITERATURE OF HOW TO INSTALL IT.
This should cut down on your electric bill, as well as reduce, or even eliminate the flickering of your lights. I’m assuming you have a 200 amp panel, it may actually be smaller or a bit larger.
By the way, there is black bitch getting fucked an even more powerful model available, the Titan SCR4 N-210.
I sort of have a similar problem. September 12th, 2007 at 7:12 am i got the titan n120 and have installed it. It is advisable to contact your power company before adding service like this. Despite the manufacturer’s claims that the unit was designed for “colder climates” and “large homes” we found the temperature increase inadequate for even washing dishes. I also did the wiring and tried to be cheap about it and didn’t buy any additional wire (the unit comes with about 18 inches of wire for each connection) so mounted the heater very close to the electrical panel. The breaker is brand new ! I have it set to max heat & can’t seem to get a full shower with consistant temperature. The water only warmed a little.
The bare was wired to the circuit panel ground and the white and black to each of the connections on the double pole breaker. the units red lights turn on when a faucet or tub is turned on and the pipe gets really hot coming out of the unit, but my problem lies in that we don’t get any hot water in any parts of the house. I spent a lot of time with the electrician trying to fix the problem which is compounded by Florida Power and Light’s (FPL) refusal to diagnose the problem as originating from them.
I spent the better part of a day removing the old electric hot water heater (which needed to be replaced) and plumbing in the connections for the unit. I’m having a problem with the lights flickering.
It just seems to pull too much water through the units and they seem to shut off.
If 15% of our electricity bill is spent on heating water and we see a 45% improvement in efficiency (see this Energy Star drum electronic set yamaha document) and our electric bill is $120 a month then we should see a savings of about $8 per month with this setup. deep brain stimulation surgery Over a month ago i had received the first heater using a buy-it-now link on eBay. You want to try using only one heater.
We let water flow through for a bridal nine shoes west while and then kicked on the breaker.